This guide will show you how to connect your Syncrobit with the included POE injector. As you may notice there is no included AC adapter, this is completely normal.
- First off lets take out the Syncrobit, antenna, poe injector and ethernet cables.
- Connect the antenna to the Syncrobit.
NOTE: NEVER power on the miner without an antenna connected!
- Connect one of the ethernet cables into the port labeled POE on the injector.
- Connect the other end of that cable into the Syncrobit. This is how you provide power to the unit.
- If you want to use an ethernet connection, continue to the steps below. Otherwise if you want to use WIFI only, you are now done the setup, plug the unit into the wall.
- Take the other ethernet cable and connect it into the LAN port of the injector and other end into your router/switch/modem and plug in the adapter to the wall.
- You are now connected with ethernet.